Pages

Friday, August 24, 2012

DIY: Reupholstered Chairs

Project: Reupholstered chairs

Here is a project that I thought would be way more complicated than it was. We inherited a beautiful dining room set from my grandparents but unfortunately the cushions were torn and stained in some spots. I had seen lots of tutorials on recovering chairs, but I had never done anything with fabric before and it was really intimidating. But alas, being poor finally forced my hand as buying new furniture was just not in the cards :)

Supplies needed:

  • Staple gun (I ordered one off of Amazon for $9.99, and it included staples and a case)
  • Fabric (I got mine from fabric.com for like $7 a yard + free shipping!)
  • Drill

Here are my chairs before:

 and my chairs after!


Step 1) Use drill to remove screws from the bottom of chair and take off cushion
Step 2) Line up cushion on fabric and make sure you cut out enough to reach about 1-2 inches around the back so you have plenty of room to staple it to the bottom



 Step 3) Remember where your screw holes are!!! I took a marker and poked a hole then circled it so I would be able to find it again (don't worry, this will be covered up by the wood and you won't be able to see it.

Step 4) Pull fabric very tight (works best with one person holding fabric and one stapling) and staple one side to the cushion. Then do the same thing with the opposite side of the fabric. Make sure that if there is a pattern (mine was chevron) that it is lined up straight before stapling the second side.
Step 5) Staple the other two sides and staple the corners last. Since I am not a perfectionist my folded corners were pretty sloppy, but it didn't matter because no one sees the bottom of the cushion.

Voila!

Photobucket

1 comment: